| Model | NF-A4x10 24V PWM |
|---|---|
| Size | 40 mm |
| Thickness | 10 mm |
| Speed range | –5000 RPM |
| Max airflow | 5.24 CFM |
| Max pressure | 1.95 mmH₂O |
| Max noise | 19.6 dBA |
| Bearing | SSO2 |
| Connector | 4-pin PWM 24V |
| Lighting | None |
| Colour | Brown |
NF-A4x10 24V PWM: Twenty-four volt version aimed at 3D printers and other 24V equipment builds
More Noctua fans · All 40mm models · Browse the full fan database
About the NF-A4x10 24V PWM
The NF-A4x10 24V PWM is a 40mm fan just 10mm thick, so it suits tight spots where a standard-depth fan will not fit. Its 5000 RPM ceiling produces 5.24 CFM of airflow against 1.95 mmH2O of static pressure. That pressure figure is the more useful one for a fan this small: it points to pushing air through a dense heatsink, vent or filter rather than simply moving free air across an open case.
Noise is rated at 19.6 dB(A) at maximum speed, so expect an audible but modest signature at full tilt, with PWM control letting the board dial it down. The SSO2 bearing is Noctua's own design. The 4-pin PWM connector is 24V, not the usual 12V, so confirm your header supplies 24V before ordering. Colour is brown and there is no lighting. The data does not list a price or release year.
Frequently asked questions
Is the Noctua NF-A4x10 24V PWM quiet?
Noctua rates it at 19.6 dB(A) at its 5000 RPM maximum. That is a modest figure for a 40mm fan, and because it is PWM-controlled, your board can lower the speed and noise when full airflow is not needed.
What is the NF-A4x10 24V PWM best used for?
With 1.95 mmH2O static pressure and 5.24 CFM airflow, it suits restricted paths such as small heatsinks, vents and filters in compact or embedded builds where a 40mm by 10mm fan is the only fit.
Will the 4-pin 24V connector work on my motherboard?
Only if your header supplies 24V. This fan's 4-pin PWM connector is rated for 24V rather than the common 12V, so check your board or controller before connecting it to avoid running it at the wrong voltage.












