| Size | 120 mm |
|---|---|
| Thickness | 28 mm |
| Speed range | –2000 RPM |
| Max airflow | 77.3 CFM |
| Max pressure | 2.97 mmH₂O |
| Max noise | 28.7 dBA |
| Bearing | Fluid Dynamic Bearing |
| Connector | 4-Pin PWM + 3-Pin ARGB |
| Lighting | ARGB |
| Colour | Black |
UNI FAN AL120 V2 is the highest airflow UNI FAN ARGB model with 77.3 CFM at 2000 RPM
More Lian Li fans · All 120mm models · Browse the full fan database
About the Lian Li UNI FAN AL120 V2 Black
The Lian Li UNI FAN AL120 V2 Black is a 120mm fan that is 28mm thick rather than the usual 25mm, so check clearance at your mounting points. Its 2000 RPM maximum produces 77.3 CFM of airflow and 2.97 mmH2O of static pressure, a balance that suits both open case ventilation and resistance such as radiators or dense filters. Buyers pushing through restricted paths should weigh the static pressure figure, while those moving free air can lean on the CFM number.
Noise is rated at 28.7 dB(A) at maximum speed, so expect the loudest operation only at full 2000 RPM. The Fluid Dynamic Bearing is the stated bearing type. A 4-Pin PWM connector handles speed control and a separate 3-Pin ARGB connector handles lighting, so your motherboard or controller needs both headers. The data does not list a price or release year, so confirm those with the retailer.
Frequently asked questions
Is the Lian Li UNI FAN AL120 V2 Black quiet?
Lian Li rates it at 28.7 dB(A) at its 2000 RPM maximum. The data does not list noise at lower speeds, but PWM control via the 4-Pin connector lets you run it below maximum.
Is this fan better for radiators or case airflow?
It lists 2.97 mmH2O static pressure and 77.3 CFM airflow at 2000 RPM, so the data shows capability for both. Higher static pressure helps against radiators and filters, while the airflow figure suits open case ventilation.
What connectors and size does the AL120 V2 Black need?
It is a 120mm fan that is 28mm thick, so confirm 28mm clearance. It uses a 4-Pin PWM connector plus a separate 3-Pin ARGB connector, meaning your board or controller needs both headers for speed and lighting.














