| Model | Light Wings 140mm PWM Reverse |
|---|---|
| Size | 140 mm |
| Thickness | 25 mm |
| Speed range | –1300 RPM |
| Max airflow | 51.4 CFM |
| Max pressure | 1.1 mmH₂O |
| Max noise | 25.5 dBA |
| Bearing | Sleeve Bearing |
| Connector | 4-pin PWM + 5V 3-pin ARGB |
| Lighting | ARGB |
| Colour | Black |
| Price | €27.50 |
Reverse blade Light Wings 140 mm black for showcase intakes giving 51.4 CFM and 20 ARGB LEDs
More be quiet! fans · All 140mm models · Browse the full fan database
About the Light Wings 140mm PWM Reverse Black
The Light Wings 140mm PWM Reverse Black is a 140mm, 25mm-thick ARGB fan rated at 1300 RPM, 51.4 CFM airflow and 1.1 mmH2O static pressure. That airflow figure suits open case ventilation and low-restriction mesh or grille positions, while the modest 1.1 mmH2O pressure means it is not the obvious pick for dense radiators or thick dust filters, where higher-pressure fans are usually preferred. The reverse designation matters for buyers planning reversed-blade mounting, so check your case or cooler layout before ordering.
Noise is listed at 25.5 dB(A), so expect a moderate sound level rather than near-silent operation at full speed. The fan uses a sleeve bearing, a 4-pin PWM connector for speed control plus a separate 5V 3-pin ARGB header, so your motherboard or controller needs both. Colour is black and the listed price is EUR 27.5; the data does not list a release year, warranty or included accessories.
Frequently asked questions
Is the Light Wings 140mm PWM Reverse Black quiet?
be quiet! lists a noise level of 25.5 dB(A) for this fan. That is a moderate figure rather than a silent rating, and the data does not specify the test distance or speed at which it was measured.
What is this fan best suited for?
With 51.4 CFM airflow and 1.1 mmH2O static pressure at 1300 RPM, it fits case ventilation and low-restriction mounting. The low pressure figure suggests dense radiators and heavy filters are not its strongest use case.
Does it need a special connector for the ARGB lighting?
Yes. The fan uses a 4-pin PWM connector for power and speed control plus a separate 5V 3-pin ARGB connector for lighting, so your motherboard or ARGB controller must provide a 5V 3-pin header.















