| Model | Light Wings 140mm PWM Reverse White |
|---|---|
| Size | 140 mm |
| Thickness | 25 mm |
| Speed range | –1300 RPM |
| Max airflow | 51.4 CFM |
| Max pressure | 1.1 mmH₂O |
| Max noise | 25.5 dBA |
| Bearing | Sleeve Bearing |
| Connector | 4-pin PWM + 5V 3-pin ARGB |
| Lighting | ARGB |
| Colour | White |
| Price | €27.50 |
White reverse blade Light Wings 140 mm pushes 51.4 CFM the correct way for chimney style builds
More be quiet! fans · All 140mm models · Browse the full fan database
About the Light Wings 140mm PWM Reverse White
The Light Wings 140mm PWM Reverse White is a 140mm, 25mm-thick fan rated at 1300 RPM, 51.4 CFM and 1.1 mmH2O static pressure. That balance of airflow and modest pressure suits case ventilation and low-restriction mesh or filter intakes more than dense radiators or heatsinks, where the 1.1 mmH2O figure is the limiting number. The listed noise rating is 25.5 dB(A) at maximum speed, so expect the quietest operation when PWM lowers the 1300 RPM ceiling.
Mounting uses standard 140mm, 25mm spacing, and the 4-pin PWM connector handles speed control while the separate 5V 3-pin ARGB header drives the lighting, so your board needs both. The bearing is listed as sleeve bearing; the data does not list a rated lifetime or warranty. The white colour and reverse orientation are the visual selling points, and at EUR 27.5 the price is part of the appeal for an ARGB fan with these specs.
Frequently asked questions
Is the Light Wings 140mm PWM Reverse White quiet?
be quiet! lists a noise rating of 25.5 dB(A) at the 1300 RPM maximum. Actual loudness depends on the PWM speed your system commands, and the data does not list noise at lower speeds.
What is this fan best used for?
With 51.4 CFM airflow and 1.1 mmH2O static pressure, it suits case ventilation and low-restriction intakes. The modest pressure figure makes it less ideal for dense radiators or restrictive heatsinks.
Does it need a special connector for the ARGB lighting?
Yes. It uses a 4-pin PWM connector for fan power and speed control plus a separate 5V 3-pin ARGB connector for lighting, so your motherboard or controller must provide a 5V ARGB header.















