| Model | Light Wings LX 120mm PWM |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | –1600 RPM |
| Max airflow | 51.5 CFM |
| Max pressure | 1.34 mmH₂O |
| Max noise | 25.5 dBA |
| Bearing | Sleeve Bearing |
| Connector | 4-pin PWM + 5V 3-pin ARGB |
| Lighting | ARGB |
| Colour | Black |
| Price | €18.90 |
Value Light Wings LX 120 mm keeps 16 hub ARGB LEDs with 51.5 CFM at a 25.5 dB(A) ceiling
More be quiet! fans · All 120mm models · Browse the full fan database
About the Light Wings LX 120mm PWM
The Light Wings LX 120mm PWM is a 120mm by 25mm ARGB fan rated at 1600 RPM, delivering 51.5 CFM of airflow against 1.34 mmH2O of static pressure. That balance points to case ventilation and low-restriction mesh or open-frame mounting rather than thick radiators or dense dust filters, where higher static pressure is usually wanted. Buyers should treat the 25.5 dB(A) figure as the manufacturer's noise rating at its rated speed, not a measured result in every system.
Mounting follows standard 120mm spacing at 25mm thickness, so clearances are typical for the size. The 4-pin PWM connector allows speed control from the motherboard, while the separate 5V 3-pin ARGB connector requires an ARGB header or compatible controller; the data does not list a bundled hub or adapter. The bearing is listed as a sleeve bearing, and the colour is black. At EUR 18.9, the listed price is the reference point for comparing it against other ARGB 120mm fans.
Frequently asked questions
Is the Light Wings LX 120mm PWM quiet?
The manufacturer lists a noise rating of 25.5 dB(A) at a maximum speed of 1600 RPM. Actual noise in your build depends on speed, mounting and other components, which the data does not quantify.
What is the Light Wings LX 120mm PWM best for?
With 51.5 CFM airflow and 1.34 mmH2O static pressure, it suits case ventilation and low-restriction mounting. The data does not position it for high-restriction radiators or dense filters.
Does the Light Wings LX 120mm PWM need a special RGB header?
Yes. It uses a 5V 3-pin ARGB connector alongside a 4-pin PWM connector, so an ARGB header or compatible controller is required. The data does not list a bundled hub or adapter.















