| Model | Stella ARGB |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 500–1600 RPM |
| Max airflow | 70 CFM |
| Max pressure | 1.3 mmH₂O |
| Max noise | 35 dBA |
| Connector | 4-pin PWM + 3-pin ARGB |
| Lighting | ARGB |
| Colour | Black |
More GELID Solutions fans · All 120mm models · Browse the full fan database
About the GELID Solutions Stella ARGB 120mm Fan
The GELID Solutions Stella ARGB 120mm is a 25 mm thick 120 mm fan with a 500–1600 RPM PWM range. Its 70 CFM airflow is the headline figure, while 1.3 mmH2O static pressure is modest, so it suits open case ventilation, rear exhaust and low-restriction mesh intakes better than dense radiators or thick dust filters. Buyers pushing air through a heatsink or radiator should expect the pressure side to be the limiting factor.
At full speed the rated noise is 35 dB(A), which is audible, so the 500 RPM floor and PWM control matter for quieter builds. The 4-pin PWM connector needs a standard fan header, and the separate 3-pin ARGB connector requires an ARGB-capable motherboard or controller; the data does not list a bundled controller. Colour is black with ARGB lighting. The data does not list a price or release year.
Frequently asked questions
Is the GELID Solutions Stella ARGB 120mm quiet?
GELID rates it at 35 dB(A) at maximum speed, which is audible rather than silent. The 500 RPM minimum and 4-pin PWM control let you run it slower for less noise, but the data does not list noise at reduced speeds.
What is the Stella ARGB 120mm best used for?
With 70 CFM airflow and 1.3 mmH2O static pressure, it fits case intake and exhaust positions with low restriction. The modest pressure figure makes it a weaker choice for dense radiators or thick filters, where higher-pressure fans are usually preferred.
Does the Stella ARGB 120mm fit my case and motherboard?
It is a standard 120 mm fan, 25 mm thick, so it fits common 120 mm mounting positions. It uses a 4-pin PWM connector for power and a separate 3-pin ARGB connector, so your motherboard or controller must support ARGB.














