| Model | TL-8015W |
|---|---|
| Size | 80 mm |
| Thickness | 15 mm |
| Speed range | –2200 RPM |
| Max airflow | 28.4 CFM |
| Max pressure | 1.25 mmH₂O |
| Max noise | 23.3 dBA |
| Bearing | S-FDB V2 Bearing |
| Connector | 4-pin PWM |
| Lighting | None |
| Colour | White |
TL-8015W is a slim white 80 mm model rated up to 2200 rpm with 28.4 CFM and 1.25 mmH2O static pressure at 23.3 dBA
More Thermalright fans · All 80mm models · Browse the full fan database
About the TL-8015W 80mm Non-LED Fan
The TL-8015W is a 15mm-thin 80mm fan, so it suits builds where a standard 25mm fan will not clear a cooler, case panel or radiator. Its 28.4 CFM airflow at 2200 RPM points to general case ventilation and low-resistance airflow duties, while the 1.25 mmH2O static pressure is modest, so expect it to work best on open mesh or unrestricted intake and exhaust positions rather than dense heatsinks or thick radiators. The rated noise is 23.3 dB(A) at full speed, which gives you a figure to weigh against your own tolerance.
Mounting follows the usual 80mm fan hole spacing, and the 4-pin PWM connector allows speed control from a compatible motherboard header. The S-FDB V2 bearing is the stated bearing type, and the fan ships in white with no lighting. The manufacturer data does not list a price or release year, so check the retailer for current pricing before ordering.
Frequently asked questions
Is the Thermalright TL-8015W quiet?
Thermalright rates the TL-8015W at 23.3 dB(A) at its 2200 RPM maximum. That is the only noise figure listed, and actual loudness depends on the speed your PWM header commands, so the data does not give figures for lower RPM settings.
What is the TL-8015W best used for?
With 28.4 CFM airflow and 1.25 mmH2O static pressure, it fits case intake and exhaust or other low-resistance spots. Its 15mm thickness helps in tight clearances. The data does not list radiator or heatsink performance, so dense cooling setups are not confirmed.
Does the TL-8015W have RGB lighting?
No. Thermalright lists the TL-8015W as Non-LED with lighting marked none, and the colour is white. It uses a 4-pin PWM connector for speed control, so any lighting would have to come from other components in your build.















