| Model | TL-C14L |
|---|---|
| Size | 140 mm |
| Thickness | 26 mm |
| Speed range | –1500 RPM |
| Max airflow | 74.3 CFM |
| Max pressure | 2 mmH₂O |
| Max noise | 26.6 dBA |
| Bearing | S-FDB Bearing |
| Connector | 4-pin PWM + 4-pin 12V RGB |
| Lighting | RGB |
| Colour | Black |
TL-C14L is a 140 mm model with twelve volt lighting rated up to 1500 rpm with 74.3 CFM and 2 mmH2O static pressure
More Thermalright fans · All 140mm models · Browse the full fan database
About the TL-C14L 140mm RGB Fan
The TL-C14L is a 140mm fan with 26mm thickness, so it fits most 140mm mounts but is slightly deeper than standard 25mm fans, which is worth checking against tight clearances. Its 74.3 CFM airflow at 1500 RPM suits case ventilation and low-restriction intake or exhaust positions, while the 2 mmH2O static pressure is modest, so it is less suited to dense radiators or heavily filtered intakes than a high-pressure fan.
Thermalright rates noise at 26.6 dB(A), which is the figure to expect from the manufacturer rather than a measured review value. The S-FDB bearing is the stated bearing type. Connection is a 4-pin PWM header for speed control plus a separate 4-pin 12V RGB connector, so your motherboard or controller needs a 12V RGB header, not a 5V addressable one. The frame is black. The data does not list a price or release year.
Frequently asked questions
Is the Thermalright TL-C14L 140mm RGB quiet?
Thermalright rates it at 26.6 dB(A) at its 1500 RPM maximum. That is the manufacturer's noise figure, not an independent measurement, so actual noise depends on the speed your PWM header runs it at.
Is the TL-C14L better for case airflow or radiators?
It lists 74.3 CFM airflow and 2 mmH2O static pressure. The airflow figure is the stronger number, so it suits case ventilation and low-restriction mounts; the modest static pressure makes it a weaker match for dense radiators or restrictive filters.
What connectors does the TL-C14L 140mm RGB need?
It uses a 4-pin PWM connector for fan speed control and a separate 4-pin 12V RGB connector for lighting. Your board or controller must provide a 12V RGB header, since the data specifies 12V RGB rather than 5V addressable lighting.















