| Model | TL-C14S |
|---|---|
| Size | 140 mm |
| Thickness | 26 mm |
| Speed range | –1500 RPM |
| Max airflow | 74.3 CFM |
| Max pressure | 2 mmH₂O |
| Max noise | 26.6 dBA |
| Bearing | S-FDB Bearing |
| Connector | 4-pin PWM + 3-pin 5V ARGB |
| Lighting | ARGB |
| Colour | Black |
TL-C14S is a 140 mm model with addressable lighting rated up to 1500 rpm with 74.3 CFM and 2 mmH2O static pressure
More Thermalright fans · All 140mm models · Browse the full fan database
About the TL-C14S 140mm ARGB Fan
The TL-C14S is a 140mm fan with 26mm thickness, so it fits most standard 140mm mounts but is slightly deeper than slim fans. Its 1500 RPM ceiling moves up to 74.3 CFM with 2 mmH2O of static pressure, a balance that suits case ventilation and airflow-focused builds; for dense radiators or thick filters, the 2 mmH2O figure is modest, so expect it to work best where resistance is low. Thermalright rates noise at 26.6 dB(A), which tells you the sound level at its rated operating point rather than a measured range across the PWM curve.
Mounting uses a 4-pin PWM connector for speed control plus a separate 3-pin 5V ARGB header for the lighting, so your board needs both a fan header and an addressable RGB header. The S-FDB bearing is the stated bearing type, and the fan is listed in black. The manufacturer data does not list a price, release year, warranty, or included accessories, so confirm those with the retailer before ordering.
Frequently asked questions
Is the Thermalright TL-C14S 140mm ARGB quiet?
Thermalright rates it at 26.6 dB(A) at up to 1500 RPM. That is the manufacturer's noise figure for the fan, and PWM control lets you run it below full speed, though the data does not list noise levels at lower RPM.
Is the TL-C14S better for case airflow or radiators?
It delivers 74.3 CFM at 2 mmH2O static pressure. The airflow figure is strong for a 140mm fan, while 2 mmH2O is modest, so it suits case ventilation and low-restriction setups more than dense radiators or thick dust filters.
What connectors does the TL-C14S ARGB need?
It uses a 4-pin PWM connector for fan speed control and a separate 3-pin 5V ARGB connector for lighting. Your motherboard or controller needs an addressable 5V ARGB header, since the lighting will not run from a standard 12V RGB header.















