| Model | D30-120 |
|---|---|
| Size | 120 mm |
| Thickness | 30 mm |
| Speed range | 250–2000 RPM |
| Max airflow | 64.3 CFM |
| Max pressure | 3.01 mmH₂O |
| Max noise | 30.2 dBA |
| Bearing | Fluid Dynamic Bearing |
| Connector | 4-pin PWM, 5V |
| Lighting | ARGB |
| Colour | Black |
30 mm thick ARGB fan with HALOS ring lighting and bridge connectors for up to four fans
More Phanteks fans · All 120mm models · Browse the full fan database
About the Phanteks D30-120
The Phanteks D30-120 is a 120mm fan built on a 30mm thick frame rather than the usual 25mm, which gives it more room for blade and motor design. Its 3.01 mmH2O static pressure is the stronger figure here, so it suits radiators, heatsinks and dense mesh filters where airflow alone struggles. The 64.3 CFM airflow keeps it usable as a general case fan too, and the 250 to 2000 RPM range lets you tune between the two roles.
Noise is rated at 30.2 dB(A), which you should read as a figure at the top of its range rather than a constant level; at lower RPM it will be quieter, though the data does not list a minimum noise value. The fluid dynamic bearing is the durability spec Phanteks lists. It connects by 4-pin PWM with a 5V ARGB header, so your board needs both a fan header and an addressable RGB header. The data does not list a price or release year.
Frequently asked questions
Is the Phanteks D30-120 quiet enough for a low-noise build?
Phanteks rates it at 30.2 dB(A), which is the noise figure for its 2000 RPM maximum. The 250 RPM minimum lets you run it slower, but the data does not list noise at lower speeds, so the 30.2 dB(A) value is the only published number.
Is the D30-120 better for radiators or as a case fan?
Its 3.01 mmH2O static pressure is the standout figure, making it a natural fit for radiators, heatsinks and restrictive filters. The 64.3 CFM airflow still supports general case use, and the 250 to 2000 RPM range covers both roles.
What connectors does the Phanteks D30-120 need?
It uses a 4-pin PWM connector for fan speed control plus a 5V ARGB connection for lighting. Your motherboard or controller needs both a PWM fan header and a 5V addressable RGB header, so check that before buying.















