| Model | YH-120I4 |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 1200–1200 RPM |
| Max airflow | 50.3 CFM |
| Max noise | 26.8 dBA |
| Bearing | Hydraulic Bearing |
| Connector | 3-pin + 3-pin ARGB |
| Lighting | ARGB |
| Colour | Black |
YH-120I4 is a 120 mm 25 mm black fan rated 1200 RPM 50.3 CFM and 26.8 dBA with ARGB lighting
More SAMA fans · All 120mm models · Browse the full fan database
About the SAMA YH-120I4 4-in-1 Kit Black Fan
The SAMA YH-120I4 kit gives you four 120mm fans, each 25mm thick and fixed at 1200 RPM. With 50.3 CFM per fan, the airflow figure points to case ventilation and general intake or exhaust duty rather than dense radiator or heatsink work, where higher static pressure usually matters more. Because the speed is fixed, you should expect a steady noise level rather than a range, and the rated 26.8 dB(A) is the number to weigh against how quiet your build needs to be.
Mounting follows standard 120mm spacing, and the 25mm thickness fits most case and cooler clearances, though the data does not list a specific screw set or mounting hardware. Each fan uses a 3-pin connector plus a separate 3-pin ARGB header, so your motherboard or controller needs an ARGB channel for the lighting. The hydraulic bearing is listed for longevity, but the data does not include an MTBF figure, warranty length, release year or price.
Frequently asked questions
Is the SAMA YH-120I4 kit quiet enough for a bedroom PC?
Each fan is rated at 26.8 dB(A) at its fixed 1200 RPM, so noise stays constant rather than ramping up. Whether that suits a bedroom depends on your tolerance, but the data lists no lower-speed mode.
Is this 4-in-1 kit best for case airflow or a radiator?
The 50.3 CFM rating at 1200 RPM suits case intake and exhaust. The data does not list a static pressure figure, so there is no manufacturer basis for recommending it on dense radiators or heatsinks.
What connectors and motherboard headers do these ARGB fans need?
Each fan uses a 3-pin fan connector plus a separate 3-pin ARGB connector. Your board or controller therefore needs both a fan header and an ARGB channel per fan, and the data does not list any adapter or hub.














