| Model | Link 3-Pack |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 300–1500 RPM |
| Max airflow | 42.6 CFM |
| Max pressure | 1.3 mmH₂O |
| Max noise | 25.3 dBA |
| Bearing | Hydraulic Bearing |
| Connector | 4-pin PWM + 3-pin ARGB |
| Lighting | ARGB |
| Colour | White |
Link 3-Pack is a 120 mm 25 mm white fan rated 300-1500 RPM 42.6 CFM and 1.3 mmH2O 25.3 dBA with ARGB lighting
More AeroCool fans · All 120mm models · Browse the full fan database
About the AeroCool Link 3-Pack White Fan
The AeroCool Link 3-Pack White uses 120mm by 25mm fans that spin from 300 to 1500 RPM, moving 42.6 CFM at a maximum static pressure of 1.3 mmH2O. That balance suits case ventilation and airflow-focused builds better than thick, dense radiators, where higher pressure fans are usually preferred. At full speed the rated noise is 25.3 dB(A), so expect a moderate hum rather than near-silent operation; the 300 RPM floor gives you room to tune it down.
Each fan uses a hydraulic bearing and connects through a 4-pin PWM header for speed control plus a 3-pin ARGB connector for lighting, so your motherboard needs both a PWM fan header and an ARGB header per fan or a suitable splitter. The white frame and ARGB lighting match white-themed builds. The data does not list a price or release year, so check current retail listings for cost.
Frequently asked questions
Is the AeroCool Link 3-Pack White quiet enough for a bedroom PC?
Its rated noise is 25.3 dB(A) at maximum 1500 RPM, which is a moderate level rather than silent. Because it starts at 300 RPM, you can lower the PWM curve for quieter everyday use.
What is the AeroCool Link 3-Pack White best used for?
With 42.6 CFM and 1.3 mmH2O static pressure, it suits case airflow and general ventilation. It is a reasonable choice for mesh-front or open-airflow builds, while dense radiators typically favor higher-pressure fans.
Does the AeroCool Link 3-Pack White need special motherboard headers?
Yes. Each fan uses a 4-pin PWM connector for speed control and a separate 3-pin ARGB connector for lighting. Your motherboard needs both header types, or you can use splitters, since the data does not list included adapters.















