| Model | TL-K12W |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | –2150 RPM |
| Max airflow | 69 CFM |
| Max pressure | 2.87 mmH₂O |
| Max noise | 27 dBA |
| Bearing | S-FDB V2 Bearing |
| Connector | 4-pin PWM + 3-pin 5V ARGB |
| Lighting | ARGB |
| Colour | White |
TL-K12W is a white performance model with ring ARGB rated up to 2150 rpm with 69 CFM and 2.87 mmH2O static pressure
More Thermalright fans · All 120mm models · Browse the full fan database
About the TL-K12W 120mm ARGB Fan
The TL-K12W balances airflow and pressure for a 120mm fan. Its 69 CFM airflow suits case intake and exhaust, while the 2.87 mmH2O static pressure rating makes it a reasonable candidate for heatsinks, radiators or filters where resistance is higher. The 2150 RPM maximum gives headroom, and the 27 dB(A) figure is the manufacturer's noise rating, so expect that level near full speed rather than at low PWM duty.
The 25mm thickness fits standard 120mm mounts, and the 4-pin PWM connector allows speed control from the motherboard. ARGB lighting uses a separate 3-pin 5V header, so your board or controller needs that connection. The S-FDB V2 bearing is the listed bearing type. The white colour is stated, but the data does not list a price or release year, so check the retailer for current pricing.
Frequently asked questions
Is the Thermalright TL-K12W quiet at full speed?
The manufacturer lists 27 dB(A) noise for this fan. That is the rated figure, and the data does not provide noise levels at lower PWM speeds, so actual quietness depends on your fan curve and setup.
Is the TL-K12W better for case airflow or radiators?
It lists 69 CFM airflow and 2.87 mmH2O static pressure at up to 2150 RPM. The airflow suits case use, while the pressure rating makes it usable on heatsinks, radiators or filtered intakes where resistance is higher.
What connectors does the TL-K12W ARGB need?
It uses a 4-pin PWM connector for fan power and speed control, plus a separate 3-pin 5V ARGB connector for lighting. Your motherboard or ARGB controller must have a 5V 3-pin header for the lighting to work.















