| Model | TL-R12 |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 400–1500 RPM |
| Max airflow | 65.25 CFM |
| Max noise | 23 dBA |
| Bearing | S-FDB Bearing |
| Connector | 4-pin PWM + 4-pin 12V RGB |
| Lighting | RGB |
| Colour | Black |
TL-R12 is a twelve volt RGB model with thirteen colours rated up to 1500 rpm with 65.25 CFM at 23 dBA for RGB builds
More Thermalright fans · All 120mm models · Browse the full fan database
About the TL-R12 120mm RGB Fan
The TL-R12 is a 120mm by 25mm fan running from 400 to 1500 RPM, moving up to 65.25 CFM at a rated 23 dB(A). That airflow figure suits case ventilation and open-airflow heatsink use more than dense radiator work, since the data lists no static-pressure value. At the 400 RPM floor the fan should be near inaudible, while 1500 RPM is where the 23 dB(A) rating applies, so expect the loudest point only at full speed.
Mounting is standard 120mm with 25mm thickness, so it fits common case and cooler positions, though the data does not list screw hole spacing. The 4-pin PWM connector handles speed control from the motherboard, and the separate 4-pin 12V RGB header is required for lighting, so your board needs that header or a controller. The S-FDB bearing is the listed bearing type. Price and release year are not listed in the data.
Frequently asked questions
Is the Thermalright TL-R12 120mm RGB a quiet fan?
The manufacturer rates it at 23 dB(A) at its 1500 RPM maximum, with a 400 RPM minimum speed. The data does not give noise figures for lower speeds, so the 23 dB(A) number represents the full-speed condition.
What is the TL-R12 best used for?
With 65.25 CFM and no listed static-pressure figure, it suits case airflow and open-fin heatsinks. For dense radiators the data gives no pressure rating, so you cannot judge radiator performance from the spec sheet alone.
Does the TL-R12 RGB need a special connector?
Yes. It uses a 4-pin PWM connector for fan speed plus a separate 4-pin 12V RGB connector for lighting. Your motherboard or a controller must provide a 12V RGB header, since the data lists 12V RGB rather than addressable lighting.















