| Model | CL-F192-PL12SW-A |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 500–2000 RPM |
| Max airflow | 65.82 CFM |
| Max pressure | 1.87 mmH₂O |
| Max noise | 31.2 dBA |
| Bearing | Hydraulic Bearing |
| Connector | 4-Pin PWM + 3-Pin ARGB |
| Lighting | ARGB |
| Colour | Black |
CL-F192-PL12SW-A is a 25 mm thick 120 mm ARGB fan reaching 2000 RPM with 65.82 CFM and 1.87 mmH2O static pressure
More Thermaltake fans · All 120mm models · Browse the full fan database
About the Thermaltake CT120 EX Reverse ARGB Sync 3-Fan Pack
The Thermaltake CT120 EX Reverse ARGB Sync 3-Fan Pack uses 120 mm fans that are 25 mm thick, so they fit standard 120 mm mounting positions. The 500 to 2000 RPM range is controlled through a 4-Pin PWM connector, letting the fan slow down at idle and ramp up under load. With 65.82 CFM of airflow against 1.87 mmH2O of static pressure, the balance leans toward case ventilation and low-restriction airflow paths rather than thick radiators or dense filters.
Noise is rated at 31.2 dB(A), which is the figure to expect near the top of the speed range rather than at 500 RPM. The hydraulic bearing is the stated bearing type. ARGB lighting runs from a separate 3-Pin ARGB connector, so the fan needs both PWM and ARGB headers or an included controller, and the data does not list one. The pack is black and carries SKU CL-F192-PL12SW-A. Price and release year are not listed in the manufacturer data.
Frequently asked questions
Is the Thermaltake CT120 EX Reverse ARGB Sync 3-Fan Pack quiet?
The manufacturer rates it at 31.2 dB(A), which is the published noise figure for the fan. The 500 RPM minimum speed suggests it can run slower, but the data does not list noise at lower speeds.
What is this fan best used for?
With 65.82 CFM airflow and 1.87 mmH2O static pressure, it suits case ventilation and airflow-focused builds. The reverse blade design and ARGB lighting are aimed at visible intake setups, though the data does not detail blade geometry.
Does the CT120 EX Reverse ARGB Sync 3-Fan Pack need special headers?
Yes, each fan uses a 4-Pin PWM connector for power and speed control plus a separate 3-Pin ARGB connector for lighting. Your motherboard or controller must provide both header types, as the data does not list an included controller.















