| Model | F12 R ARGB |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 500–1500 RPM |
| Max airflow | 52.75 CFM |
| Max pressure | 1.76 mmH₂O |
| Max noise | 28 dBA |
| Bearing | Hydraulic Bearing |
| Connector | 4-pin PWM + 3-pin ARGB |
| Lighting | ARGB |
| Colour | Black |
Antec F12 Racing ARGB is a 120 mm 25 mm fan rated 500-1500 RPM with 52.75 CFM and 1.76 mmH2O at 28 dBA
More Antec fans · All 120mm models · Browse the full fan database
About the Antec F12 Racing ARGB 120mm ARGB Fan
The Antec F12 Racing ARGB 120mm is a 25 mm thick, 120 mm fan that runs from 500 to 1500 RPM. Its 52.75 CFM airflow and 1.76 mmH2O static pressure sit in a balanced middle ground, so it suits case ventilation and airflow-focused mounting better than dense radiators or heavily restricted intakes, where higher static pressure helps. Buyers should treat the 28 dB(A) rating as the manufacturer figure at its rated operation, not a guarantee at every speed; the 500 RPM minimum gives a lower-speed option.
Mounting is standard 120 mm with 25 mm thickness, so clearances match common case and cooler spacing. The 4-pin PWM connector allows speed control from a motherboard header, while the separate 3-pin ARGB connector needs an ARGB header or controller for lighting. The hydraulic bearing is the stated bearing type. The data does not list a price or release year, so check the retailer for current pricing.
Frequently asked questions
Is the Antec F12 Racing ARGB 120mm quiet?
Antec rates it at 28 dB(A), and it can run as low as 500 RPM. That minimum speed gives you a slower option, but the data does not break noise down per speed, so expect the 28 dB(A) figure at rated operation.
What is the Antec F12 Racing ARGB 120mm best for?
With 52.75 CFM airflow and 1.76 mmH2O static pressure, it is balanced for case airflow and general ventilation. It is less specialised for high-restriction radiators, where higher static pressure is usually preferred.
Does the Antec F12 Racing ARGB 120mm fit my case and motherboard?
It is a standard 120 mm fan, 25 mm thick, so it fits common 120 mm mounting points. It uses a 4-pin PWM connector for speed control plus a separate 3-pin ARGB connector, so your board or controller needs an ARGB header.















