| Model | Neon 120 ARGB |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 800–1600 RPM |
| Max airflow | 35 CFM |
| Max pressure | 1.38 mmH₂O |
| Max noise | 25.6 dBA |
| Bearing | Hydraulic Bearing |
| Connector | 4-pin PWM + 3-pin ARGB |
| Lighting | ARGB |
| Colour | Black |
Antec NEON 120 ARGB is a 120 mm 25 mm fan rated 800-1600 RPM with 35 CFM and 1.38 mmH2O at 25.6 dBA
More Antec fans · All 120mm models · Browse the full fan database
About the Antec NEON 120 ARGB 120mm ARGB Fan
The Antec NEON 120 ARGB 120mm is a 120mm by 25mm fan that runs from 800 to 1600 RPM through a 4-pin PWM connector, so you can tune speed to your build. Its 35 CFM airflow and 1.38 mmH2O static pressure sit toward the lower-pressure side, which suits case ventilation and low-resistance mesh or open-airflow setups better than dense radiators or thick dust filters. At 25.6 dB(A) the noise figure is moderate rather than silent, so expect some audible airflow near the top of the range.
The hydraulic bearing is a useful detail for buyers planning long-term use, and the separate 3-pin ARGB header means lighting control depends on your motherboard or controller having that connection. Colour is black and lighting is ARGB. The manufacturer data does not list a price or release year, so check current retail listings for cost. Confirm your case supports 120mm mounts and that you have both a PWM fan header and an ARGB header free before ordering.
Frequently asked questions
Is the Antec NEON 120 ARGB 120mm quiet?
Antec rates it at 25.6 dB(A), which is a moderate noise level rather than a silent one. Because it spans 800 to 1600 RPM via PWM, you can lower the speed to reduce noise if your thermals allow.
Is this fan better for case airflow or a radiator?
Its 35 CFM airflow and 1.38 mmH2O static pressure favour case ventilation and low-resistance mesh setups. Dense radiators or thick filters usually benefit from higher static pressure than this figure suggests.
What connectors does the Antec NEON 120 ARGB 120mm need?
It uses a 4-pin PWM connector for fan speed and a separate 3-pin ARGB connector for lighting. Your motherboard or controller needs both a free PWM fan header and an ARGB header for full control.















