| Model | HURRICANE MAG 120 |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 300–2000 RPM |
| Max airflow | 54.82 CFM |
| Max pressure | 2.74 mmH₂O |
| Max noise | 23.36 dBA |
| Bearing | Sleeve Bearing |
| Connector | 4-pin PWM + 3-pin ARGB |
| Lighting | ARGB |
| Colour | Black |
HURRICANE MAG 120 is a 120 mm 25 mm black fan rated 300-2000 RPM 54.82 CFM and 2.74 mmH2O 23.36 dBA
More XPG fans · All 120mm models · Browse the full fan database
About the XPG HURRICANE MAG 120 Fan
The XPG HURRICANE MAG 120 is a 120mm, 25mm-thick fan built around a 300–2000 RPM range. Its 54.82 CFM airflow and 2.74 mmH2O static pressure make it a reasonable all-rounder: the pressure figure is high enough to push through a radiator or a dust filter, while the airflow suits open case ventilation. Buyers should note the 23.36 dB(A) rating is a single manufacturer figure, so expect more noise near the 2000 RPM ceiling and less near the 300 RPM floor.
Mounting is standard 120mm with 25mm thickness, so it fits typical case and cooler positions. It uses a 4-pin PWM connector for speed control plus a separate 3-pin ARGB header, meaning your motherboard needs an ARGB header or a compatible controller. The bearing is listed as sleeve bearing, which is worth checking against your mounting orientation. The data does not list a price or release year, so confirm those with the retailer.
Frequently asked questions
Is the XPG HURRICANE MAG 120 quiet?
XPG rates it at 23.36 dB(A) across its 300–2000 RPM range. That is a single manufacturer figure, so expect louder operation near the 2000 RPM maximum and quieter running closer to the 300 RPM minimum.
What is the XPG HURRICANE MAG 120 best used for?
With 54.82 CFM airflow and 2.74 mmH2O static pressure, it suits both case ventilation and restricted airflow paths such as radiators or filtered intakes. The 120mm size and 25mm thickness fit standard mounting points.
Does the XPG HURRICANE MAG 120 need a special header for RGB?
Yes. It uses a 4-pin PWM connector for fan speed plus a separate 3-pin ARGB connector for lighting. Your motherboard or controller needs a 3-pin ARGB header to drive the ARGB lighting.














