| Model | P12R ARGB |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 600–1500 RPM |
| Max airflow | 61.46 CFM |
| Max pressure | 1.07 mmH₂O |
| Max noise | 29.5 dBA |
| Bearing | Hydraulic Bearing |
| Connector | 4-pin PWM + 3-pin ARGB |
| Lighting | ARGB |
| Colour | Black |
Antec P12R ARGB is a 120 mm 25 mm fan rated 600-1500 RPM with 61.46 CFM and 1.07 mmH2O at 29.5 dBA
More Antec fans · All 120mm models · Browse the full fan database
About the Antec P12R ARGB 120mm Reverse ARGB Fan
The Antec P12R ARGB 120mm Reverse runs from 600 to 1500 RPM through a 4-pin PWM connector, so you can tune speed to load rather than accept a fixed airflow level. Its 61.46 CFM rating is the headline figure, while 1.07 mmH2O static pressure is modest, which points to open case ventilation and low-impedance mesh or filter positions rather than dense radiators or heatsinks. Buyers pushing air through restrictive fins should weigh that pressure number carefully.
At full speed Antec rates the fan at 29.5 dB(A), so expect audible airflow at 1500 RPM and a quieter result near the 600 RPM floor. The hydraulic bearing is specified for long-life, low-maintenance operation. Mounting follows the standard 120mm, 25mm-thick format, and the 3-pin ARGB header is separate from the 4-pin PWM header, so your board or controller needs both connections. The data does not list a price or release year.
Frequently asked questions
Is the Antec P12R ARGB 120mm Reverse quiet at full speed?
Antec rates it at 29.5 dB(A) at its 1500 RPM maximum. Because it is PWM controlled down to 600 RPM, you can lower speed and noise when full airflow is not needed. The data does not include measured noise at lower speeds.
What is the Antec P12R ARGB 120mm Reverse best suited for?
With 61.46 CFM airflow and 1.07 mmH2O static pressure, it suits case ventilation and low-restriction mesh or filter positions. Its modest pressure rating makes it a weaker match for dense radiators or tightly finned heatsinks, where higher pressure fans are usually preferred.
What connectors does the Antec P12R ARGB 120mm Reverse need?
It uses a 4-pin PWM connector for fan speed control plus a separate 3-pin ARGB connector for lighting. Your motherboard or ARGB controller must provide both headers. It fits standard 120mm mounting points at 25mm thickness.















