| Model | AX140 PWM |
|---|---|
| Size | 140 mm |
| Thickness | 25 mm |
| Speed range | 600–1600 RPM |
| Max airflow | 90.5 CFM |
| Max pressure | 2.9 mmH₂O |
| Max noise | 27.9 dBA |
| Bearing | Sleeve Bearing |
| Connector | 4-pin PWM + 3-pin ARGB |
| Lighting | ARGB |
| Colour | White |
AX140 PWM is a 140 mm 25 mm white fan rated 600-1600 RPM 90.5 CFM and 2.9 mmH2O 27.9 dBA with ARGB lighting
More Montech fans · All 140mm models · Browse the full fan database
About the MONTECH AX140 PWM White Fan
The MONTECH AX140 PWM White is a 140 mm, 25 mm thick fan built for buyers who need both volume and pressure. Its 90.5 CFM airflow and 2.9 mmH2O static pressure mean it suits radiators, dense heatsinks and mesh-front cases where a low-pressure fan would stall. The 600 to 1600 RPM range lets you tune it down for everyday use or push it when loads rise.
Noise is rated at 27.9 dB(A), so expect audible airflow near the top of the range rather than silence. The sleeve bearing is a simple, low-cost design, and the data does not list a rated lifespan or a release year. Mounting is standard 140 mm with a 4-pin PWM connector for speed control plus a 3-pin ARGB header for lighting, so your board needs an ARGB header to use the LEDs. Price is not listed in the data.
Frequently asked questions
Is the MONTECH AX140 PWM White quiet enough for a quiet build?
It is rated at 27.9 dB(A) at its maximum 1600 RPM. Because it starts at 600 RPM, you can lower the speed with the 4-pin PWM signal for quieter running, but the data does not list noise at reduced speeds.
What is the MONTECH AX140 PWM White best used for?
With 90.5 CFM airflow and 2.9 mmH2O static pressure, it is suited to radiators, dense heatsinks and restrictive front panels. The pressure figure matters more than raw airflow when a fan must push through obstacles.
Does the MONTECH AX140 PWM White need a special motherboard header for RGB?
Yes. It uses a 4-pin PWM connector for fan speed and a separate 3-pin ARGB connector for lighting. Your motherboard or controller needs a 3-pin ARGB header, otherwise the fan will spin but the lighting will not be controlled.















