| Model | PH-F120M25_DRGB_PWM_BK01 |
|---|---|
| Size | 120 mm |
| Thickness | 25 mm |
| Speed range | 500–2000 RPM |
| Max airflow | 84.26 CFM |
| Max pressure | 2.67 mmH₂O |
| Max noise | 35.7 dBA |
| Bearing | Hydraulic Bearing |
| Connector | 4-Pin PWM Daisy-chain + 3-Pin D-RGB |
| Lighting | ARGB |
| Colour | Black |
Phanteks M25-120 is a 120 mm 25 mm fan rated 500-2000 RPM with 84.26 CFM and 2.67 mmH2O at 35.7 dBA
More Phanteks fans · All 120mm models · Browse the full fan database
About the Phanteks M25-120 120mm D-RGB Fan
The Phanteks M25-120 120mm D-RGB balances airflow and pressure for a 25 mm thick 120 mm fan. Its 84.26 CFM airflow suits open case ventilation, while the 2.67 mmH2O static pressure figure makes it a reasonable candidate for pushing air through radiators or dense mesh filters. The 500 to 2000 RPM range lets you tune between low-speed running and full-speed headroom, and the listed noise figure is 35.7 dB(A), so expect the loudest point at maximum RPM rather than at the low end.
Mounting follows standard 120 mm spacing with a 25 mm thickness, and the 4-pin PWM daisy-chain connector plus separate 3-pin D-RGB header means you need both a PWM fan header and an ARGB header for lighting. The hydraulic bearing and black finish are listed; the data does not list a price or release year, so check the retailer for current pricing.
Frequently asked questions
Is the Phanteks M25-120 120mm D-RGB quiet?
The listed noise figure is 35.7 dB(A) at its maximum 2000 RPM. Because the fan ranges from 500 to 2000 RPM, you can run it slower for less noise, but the data does not provide noise measurements at lower speeds.
What is the Phanteks M25-120 best used for?
With 84.26 CFM airflow and 2.67 mmH2O static pressure, it suits both case ventilation and higher-resistance spots such as radiators or dense filters. The 25 mm thickness fits standard 120 mm mounting positions.
Does the Phanteks M25-120 120mm D-RGB need a special header?
Yes. It uses a 4-pin PWM daisy-chain connector for fan power and speed control, plus a separate 3-pin D-RGB connector for the ARGB lighting. Your motherboard or controller needs an ARGB header for the lights to work.















